Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009TUCSON LIMITED, 2.0 BREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXAUTOMATIC TRANSAXLE SYSTEM DTCS
2009 Hyundai Tucson Limited, 2.0 B
Automatic Transaxle System DTCS
2009 Hyundai Tucson Limited, 2.0 BSECTION Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE DTC (LIST)
| DTC No. | DESCRIPTION |
|---|---|
| P0560 | System Voltage |
| P0605 | Internal Control Module Read Only Memory (ROM) Error |
| P0703 | Stop Lamp (Brake) Switch Circuit Malfunction |
| P0707 | Transmission Range Sensor Circuit Low Input |
| P0708 | Transmission Range Sensor Circuit High Input |
| P0711 | Transmission Fluid Temperature Sensor "A" Circuit Range/Performance |
| P0712 | Transmission Fluid Temperature Sensor "A" Circuit Low Input |
| P0713 | Transmission Fluid Temperature Sensor "A" Circuit High Input |
| P0715 | Input/Turbine Speed Sensor "A" Circuit No Signal |
| P0717 | Input/Turbine Speed Sensor "A" Circuit No Signal |
| P0720 | Output Speed Sensor (Pulse Generator B) Circuit No Signal |
| P0721 | Output Speed Sensor Circuit Range/Performance |
| P0722 | Output Speed Sensor Circuit No Signal |
| P0731 | Gear 1 Incorrect Ratio |
| P0732 | Gear 2 Incorrect Ratio |
| P0733 | Gear 3 Incorrect Ratio |
| P0734 | Gear 4 Incorrect Ratio |
| P0741 | Torque Converter Clutch Circuit Stock off |
| P0742 | Torque Converter Clutch Circuit Stock on |
| P0743 | Torque Converter Clutch Circuit Electrical |
| P0750 | Shift Control Solenoid Valve "A" (Low-Reverse Brake Control Solenoid)-Open or Short |
| P0755 | Shift Control Solenoid Valve "B" (Under Drive Solenoid)-Open or Short |
| P0760 | Shift Control Solenoid Valve "C" (2nd Brake Control Solenoid) - Open or Short |
| P0765 | Shift Control Solenoid Valve "D" (Over Drive Solenoid)-Open or Short |
| P0885 | TCM Power Relay Open or Short (Ground) |
| P1500 | Vehicle Speed Sensor Signal Circuit Malfunction |
| U0001 | CAN Communication Bus Off |
| U0100 | Lost Communication With ECM/PCM "A1 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.