Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009TUCSON LIMITED, 2.0 BREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSDTC CODES - HVAC SYSTEMB1242 EVAPORATOR SENSOR OPEN (HIGH)MONITOR SCAN TOOL DATA
2009 Hyundai Tucson Limited, 2.0 B
Monitor Scan Tool Data
2009 Hyundai Tucson Limited, 2.0 BSECTION Monitor Scan Tool Data
- Connect scan tool to Data Link Connector (DLC).
- Engine "ON"
- Monitor the "Evaporative Sensor" parameter on the Scan Tool.
- Is the DTC B1242 present and is parameter of "Evaporative Sensor" fixed?
* Parameter of "Evaporative Sensor" will be fixed at -2°C (28.4°F), if there is any fault in Evaporative Sensor.
YES
- Go to "INSPECTION " procedure.
NO
- The electrical systems are made up of many harness and connectors. Many kinds of fault are caused by poor connection of sensors and terminals. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.