Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2009TUCSON LIMITED, 2.0 BREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISDTC TROUBLESHOOTING PROCEDURES (2.0L)TROUBLESHOOTING FOR DTCP0335 CRANKSHAFT POSITION SENSOR CIRCUIT MALFUNCTIONSIGNAL CIRCUIT INSPECTION

2009 Hyundai Tucson Limited, 2.0 B

Signal Circuit Inspection

2009 Hyundai Tucson Limited, 2.0 BSECTION Signal Circuit Inspection

Check for open in signal harness.
1. Disconnect PCM connector.
2. Measure resistance between terminals 2 of sensor harness connector and 29 of the PCM harness connector.
  Specification : Approx. 0Ω
  
  Fig 1: Measuring Resistance Between Terminals 2 Of Sensor Harness Connector And PCM Harness Connector
  Courtesy of HYUNDAI MOTOR AMERICA
3. Is resistance within the specification?
  YES
  - Go to next step as below.
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check for short to ground in signal harness.
1. Measure resistance between terminal 2 of sensor harness connector and chassis ground.
  Specification : Infinite
  
  Fig 2: Measuring Resistance Between Terminal 2 Of Sensor Harness Connector And Chassis Ground
  Courtesy of HYUNDAI MOTOR AMERICA
2. Is resistance within the specification?
  YES
  - Go to next step as below.
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
Check for short to power in signal harness.
1. Ignition "ON" & Engine "OFF".
2. Measure voltage between terminal 2 of the sensor harness connector and chassis ground.
  Specification : Approx. 0V
  
  Fig 3: Measuring Voltage Between Terminal 2 Of Sensor Harness Connector And Chassis Ground
  Courtesy of HYUNDAI MOTOR AMERICA
3. Is voltage within the specification?
  YES
  - Go to "COMPONENT INSPECTION " procedure.
  NO
  - Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.