Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009TUCSON LIMITED, 2.0 BREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE (G4GC-GSL 2.0L)COOLING SYSTEMINSTALLATIONWATER PUMP
2009 Hyundai Tucson Limited, 2.0 B
Water Pump
2009 Hyundai Tucson Limited, 2.0 BSECTION Water Pump
- Install the water pump.
- Install the water pump (B) and a new gasket with the 3 bolts.
Tightening torque
20 ~ 27 Nm (200 ~ 270 kgf.cm, 15 ~ 20 lbf.ft)
- Install the alternator brace (A) with the 2 bolts (C).
- Install the 4 bolts and pump pulley.
- Install the water pump (B) and a new gasket with the 3 bolts.
- Install the timing belt idler. (See INSTALLATION )
- Install the timing belt. (See INSTALLATION )
- Install drive belts.
- Fill with engine coolant.
- Start engine and check for leaks.
- Recheck engine coolant level.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.