SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009SONATA SE, 3.3 FREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSMISSION SYSTEM - A5HF1TROUBLESHOOTINGP0708 TRANSMISSION RANGE SENSOR CIRCUIT HIGH INPUTDTC DETECTING CONDITION
2009 Hyundai Sonata SE, 3.3 F

P0708 Transmission Range Sensor Circuit High Input: DTC Detecting Condition

2009 Hyundai Sonata SE, 3.3 FSECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Check for multiple signals
  • Open or short in TRANSAXLE RANGE SWITCH
  • Faulty TRANSAXLE RANGE SWITCH
  • Faulty PCM
Enable Conditions
  • Ne ≥ 400rpm
  • 11V ≤ Battery Voltage ≤ 16V
Threshold Value
  • Multiple signal
Diagnostic Time
  • More than 30sec
Fail Safe
  • Recognition as previous signal
    • When signal is input "D" and "N" at the same time. TCM regards it as "N" RANGE.
    • After PCM/TCM Reset, If the if the PCM/TCM detects multiple signal or no signal, then it holds the 3rd gear position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.