SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009SONATA SE, 3.3 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 15 (AUTOMATIC TRANSAXLE CONTROL SYSTEM - A5GF1)INPUT SPEED SENSORDESCRIPTION
2009 Hyundai Sonata SE, 3.3 F

Input Speed Sensor: Description

2009 Hyundai Sonata SE, 3.3 FSECTION Description
WARNING: This page is about a different variant/trim than selected.
INPUT SPEED SENSOR DESCRIPTION CHART

Sensor type
  1. Type: HALL SENSOR
  2. Operating voltage : DC 12V
  3. Current consumption : 22mA (Max)
Function
  1. Input speed sensor: Detect the OD & REV retainer rotation to control oil pressure when shifting.
  2. Feedback control, clutch-clutch control, damper clutch control, shift range control, incorrect ratio control and sensor trouble detection signal.
Connector
G05348805Courtesy of HYUNDAI MOTOR CO.
Fig 1: Identifying Input Speed Sensor
G05348806Courtesy of HYUNDAI MOTOR CO.
INPUT SPEED SENSOR DESCRIPTION CHART

Item Inspection item Standard value
Air gap Input speed sensor 0.05in (1.3mm)
Sensor resistance Input speed sensor Over 1 MΞ©
Output voltage HIGH Over 4.8V
LOW Below 0.8V
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.