C1237 Primary Pressure Sensor-Signal: DTC Detecting Condition

2009 Hyundai Sonata SE, 3.3 FSECTION DTC Detecting Condition
DTC DETECTING CONDITION AND POSSIBLE CAUSE

Item Detecting Condition Possible cause
DTC Strategy
  • Voltage Monitoring
  • Open or short of pressure sensor circuit
  • Faulty pressure sensor
  • Faulty HECU
Monitoring Period
  • After Pressure sensor initialization.
  • No under voltage
  • No pumps are running.
  • No BLS-signal is set.
Enable Conditions
  • The pressure sensor-offset value must be in the range of Β± 15 bar. A failure is detected if this range is exceeded.
Fail Safe
  • Reduced function caused by faulty pressure sensor signal.
  • Sensor failure outside the ABS control cycle
    • Only the ABS/ESC functions are inhibited, allow the EBD. The ABS/ESC warning lamps are activated and the EBD warning lamp is not activated.
  • Sensor failure inside the ABS control cycle
    • Inhibit the ESC control, allow the EBD. The ESC warning lamps are activated. After the control, the ABS functions are inhibited. The ABS warning lamps are activated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.