ABS/ESC Sensor Output List

2009 Hyundai Sonata SE, 3.3 FSECTION ABS/ESC Sensor Output List
ABS AND ESC SENSOR OUTPUT LIST

  Display (Hi-DS Scanner) Abbreviation Unit Remarks
1 Engine Speed ENG. SPD RPM ESC Only
2 Vehicle Speed VEH. SPD Km/h  
3 Throttle P. Sensor TP. SNSR % ESC Only
4 Shift Lever Position SHIFT POSI. - ESC Only
5 Battery Voltage BATT. VOL V  
6 Wheel Speed Snsr - FL FL Wheel Km/h  
7 Wheel Speed Snsr - FR FR Wheel Km/h  
8 Wheel Speed Snsr - RL RL Wheel Km/h  
9 Wheel Speed Snsr - RR RR Wheel Km/h  
10 ABS Warning Lamp ABS Lamp -  
11 EBD Warning Lamp EBD Lamp -  
12 ESC Function Lamp ESC Lamp - ESC Only
13 ESC Off Lamp ESC Off - ESC Only
14 ESC Off Switch ESC SW - ESC Only
15 Brake Lamp Switch B/Lamp -  
16 Pump Relay State Pump RLY -  
17 Valve Relay State Valve RLY -  
18 Motor Motor -  
19 FL Valve (IN) FL Inlet -  
20 FR Valve (IN) FR Inlet -  
21 RL Valve (IN) RL Inlet -  
22 RR Valve (IN) RR Inlet -  
23 FL Valve (OUT) FL Outlet -  
24 FR Valve (OUT) FR Outlet -  
25 RL Valve (OUT) RL Outlet -  
26 RR Valve (OUT) RR Outlet -  
27 TCS Valve (USV)1 USV1 - ESC ONLY
28 TCS Valve (USV)1 USV2 - ESC ONLY
29 ESC Valve (HSV1) HSV1 - ESC ONLY
30 ESC Valve (HSV2) HSV2 - ESC ONLY
31 Steering Angle Snsr SAS deg -780 ~ 779.9° (ESC Only)
32 Yaw Rate Snsr - Lateral Lateral g -1.8 ~ 1.8 G (ESC Only)
33 Yaw Rate Snsr - Yaw Yaw deg/S -100 ~ 100 deg/s (ESC Only)
34 Pressure Sensor PRES. SNSR bar -42.5 ~ 425 bar (ESC Only)
35 Parking Brake Signal P/Brake - ESC Only
37 SAS Calibrated SAS CALL - ESC Only
38 Yaw Rate Sensor Test Passed Yaw Test - ESC Only
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.