Supplemental Restraints System Control Module (SRSCM): Removal

2009 Hyundai Azera LimitedSECTION Removal
WARNING: This page is about a different car, the 2008 Hyundai Azera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
  2. Remove the ignition key from the vehicle.
  3. Disconnect the DAB, PAB, SAB, CAB, BPT and BUPT connectors.
  4. Remove the floor console and heater ducts. (Refer to INTERIOR )
  5. Disconnect the SRSCM harness connector (A) and (B) from the SRSCM.
    Fig 1: Identifying SRSCM Harness Connector And SRSCM
    G05536761Courtesy of HYUNDAI MOTOR CO.
  6. Remove the SRSCM mounting bolts (4EA) from the SRSCM, then remove the SRSCM.
    Fig 2: Identifying SRSCM Mounting Bolts And SRSCM
    G04880666Courtesy of HYUNDAI MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.