Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2009AZERA LIMITEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (AIR BAG RESTRAINT SYSTEM)SRS CONTROL SYSTEMSEAT TRACK POSITION SENSORINSTALLATION
2009 Hyundai Azera Limited
Seat Track Position Sensor: Installation
2009 Hyundai Azera LimitedSECTION Installation
WARNING: This page is about a different car, the 2008 Hyundai Azera. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to install the harness wires not to be pinched or interfered with other parts.
- Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
- Remove the ignition key from the vehicle.
- Install the STPS with two screws.
- Install the front seat assembly. (Refer to SEAT )
- Reconnect the battery negative cable.
- After installing the Seat Track Position Sensor, confirm proper system operation:
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.