Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2008ENTOURAGE V6-3.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCRANKSHAFT MAIN BEARING
2008 Hyundai Entourage V6-3.8L
Crankshaft Main Bearing
2008 Hyundai Entourage V6-3.8LSECTION Crankshaft Main Bearing
Main journal outer diameter 68.942 - 68.960mm (2.7142 - 2.7149in.)
Pin journal outer diameter 54.954 - 54.972mm (2.1635 - 2.1642in.)
Main bearing oil clearance 0.022 - 0.040mm (0.0008 - 0.0016in.)
Main bearing cap bolt 49.00Nm(5.0 kgf.m, 36.16lb-ft) + 90° (1 - 8)
19.60 Nm(2.0 kgf.m, 14.46lb-ft)+ 120° (9 - 16)
29.40 - 31.36Nm(3.0 - 3.2 kgf.m, 21.70 - 23.14lb-ft) (17 - 22)
Pin journal outer diameter 54.954 - 54.972mm (2.1635 - 2.1642in.)
Main bearing oil clearance 0.022 - 0.040mm (0.0008 - 0.0016in.)
CONNECTING ROD MARK LOCATION:
DISCRIMINATION OF CONNECTING ROD:
CRANKSHAFT PIN MARK LOCATION DISCRIMINATION OF CRANKSHAFT:
DISCRIMINATION OF CRANKSHAFT:
PLACE OF IDENTIFICATION MARK (CONNECTING ROD BEARING):
DISCRIMINATION OF CONNECTING ROD BEARING:
DISCRIMINATION OF CYLINDER BLOCK:
CRANKSHAFT JOURNAL MARK LOCATION DISCRIMINATION OF CRANKSHAFT:
DISCRIMINATION OF CRANKSHAFT:
PLACE OF IDENTIFICATION MARK (CRANKSHAFT BEARING):
DISCRIMINATION OF CRANKSHAFT BEARING:
SELECTION:
Main bearing cap bolt 49.00Nm(5.0 kgf.m, 36.16lb-ft) + 90° (1 - 8)
19.60 Nm(2.0 kgf.m, 14.46lb-ft)+ 120° (9 - 16)
29.40 - 31.36Nm(3.0 - 3.2 kgf.m, 21.70 - 23.14lb-ft) (17 - 22)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.