Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2008ENTOURAGE V6-3.8LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEDOOR MODULESERVICE AND REPAIR
2008 Hyundai Entourage V6-3.8L
Door Module: Service and Repair
2008 Hyundai Entourage V6-3.8LSECTION Service and Repair
MULTIPLEX COMMUNICATION
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the front door lower panel.
3. Remove the door module (A) mounting screws (5EA) after disconnecting module connector (3EA).
4. Remove the door module (DDM/ADM) (A) from the front door trim panel.
REPLACEMENT
1. Disconnect the negative (-) battery terminal.
2. Remove the front door lower panel.
3. Remove the door module (A) mounting screws (5EA) after disconnecting module connector (3EA).
4. Remove the door module (DDM/ADM) (A) from the front door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.