Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2008ENTOURAGE V6-3.8LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSPOWER LOCKSPOWER DOOR LOCK SWITCHSERVICE AND REPAIR
2008 Hyundai Entourage V6-3.8L
Power Door Lock Switch: Service and Repair
2008 Hyundai Entourage V6-3.8LSECTION Service and Repair
POWER DOOR LOCK SWITCH
REPLACEMENT
DDM/ADM
1. Disconnect the negative battery terminal.
2. Remove the front door trim panel.
3. Remove the door module (A) mounting screws (5EA) after disconnecting the connector (3EA) from the actuator.
4. Remove the front door modules (DDMDM) from the front door trim panel.
REPLACEMENT
DDM/ADM
1. Disconnect the negative battery terminal.
2. Remove the front door trim panel.
3. Remove the door module (A) mounting screws (5EA) after disconnecting the connector (3EA) from the actuator.
4. Remove the front door modules (DDMDM) from the front door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.