Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005TIBURON L4-2.0LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCRANKSHAFT MAIN BEARING
2005 Hyundai Tiburon L4-2.0L
Crankshaft Main Bearing
2005 Hyundai Tiburon L4-2.0LSECTION Crankshaft Main Bearing
Crankshaft bearing
Oil clearance 0.028 - 0.046 mm (0.0011 - 0.0018 inch)
Main Bearing Cap
Install and uniformly tighten the 10 bearing cap bolts (A), in several passes, in the sequence shown.
Retighten the bearing cap bolts by 600-650 in the numerical order shown.
Oil clearance 0.028 - 0.046 mm (0.0011 - 0.0018 inch)
Main Bearing Cap
Install and uniformly tighten the 10 bearing cap bolts (A), in several passes, in the sequence shown.
Retighten the bearing cap bolts by 600-650 in the numerical order shown.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.