Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005TIBURON L4-2.0LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
2005 Hyundai Tiburon L4-2.0L
Connecting Rod Bearing
2005 Hyundai Tiburon L4-2.0LSECTION Connecting Rod Bearing
Connecting Rod Cap
Torque 50 - 53 Nm ((500 - 530 kgf-cm, 36-39 ft. lbs)
Connecting rod bearing
Oil clearance (To seat limits to new parts) 0.024 - 0.042 mm (0.0009 - 0.0016 inch)
Undersize 0.25 mm (0.01 inch)
Torque 50 - 53 Nm ((500 - 530 kgf-cm, 36-39 ft. lbs)
Connecting rod bearing
Oil clearance (To seat limits to new parts) 0.024 - 0.042 mm (0.0009 - 0.0016 inch)
Undersize 0.25 mm (0.01 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.