Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005SANTA FE GLS, 2.7 D, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (FUEL SYSTEM (G6CU-GSL 3.5))GASOLINE ENGINE CONTROL SYSTEMPOWERTRAIN CONTROL MODULE (PCM) CONNECTOR TERMINAL ARRANGEMENTTERMINAL RESISTANCE AND CONTINUITY CHECK
2005 Hyundai Santa Fe GLS, 2.7 D, AWD
Terminal Resistance And Continuity Check
2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Terminal Resistance And Continuity Check
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch to OFF.
- Disconnect the PCM connector.
- Measure the resistance and check for continuity between the terminals of the PCM harness-side connector while referring to PCM HARNESS-SIDE CONNECTOR TERMINALS SPECIFICATIONS CHART
.NOTE:
- When measuring resistance and checking continuity, a harness for checking connect pin pressure should be used instead of inserting a test probe.
- Checks do not have to be carried out in the order given in PCM HARNESS-SIDE CONNECTOR TERMINALS SPECIFICATIONS CHART .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.