Fuel Pump (FP): Inspection

2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Inspection
WARNING: This page is about a different variant/trim than selected.
  1. Check the hoses and the pipes for cracks or damage.
  2. Check the fuel tank cap for proper operation.
  3. Check the fuel tank for deformation, corrosion or cracking.
  4. Check the fuel tank inside for dirt or contamination.
  5. Check the in-tank fuel filter for damage or restriction.
  6. Test the two-way valve for proper operation.
  7. Using a vacuum hand pump, check the operation of the two-way valve.
    TWO-WAY VALVE SPECIFICATIONS

    Valve pump Guide lines for acceptance or rejection
    When connected to inlet side Negative pressure generated and vacuum maintained
    When connected to outlet side No negative pressure generated]
    Fig 1: Checking Operation Of Two-Way Valve
    G03845915Courtesy of HYUNDAI MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.