Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005SANTA FE GLS, 2.7 D, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE (G6CU-GSL 3.5L))TIMING SYSTEMTIMING BELTINSTALLATION
2005 Hyundai Santa Fe GLS, 2.7 D, AWD
Timing Belt: Installation
2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Installation
WARNING: This page is about a different variant/trim than selected.
The method of installing timing belt and auto tensioner.
- Install idler pulley to engine support lower bracket.
- Install tensioner arm, shaft and plane washer to cylinder block.
Tightening torque : 35 ~55 Nm (350 ~ 550 kg.cm)
- Install crankshaft sprocket and align the timing mark.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.