DTC P0134: Ho2S Circuit No Activity Detected (Bank 1/Sensor 1): DTC Detecting Condition

2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
Case 1) DTC Strategy
  • Signal plausibility during fuel cut off
  • Related fuse blown or missing
  • Contact resistance in connectors
  • HO2S contamination
Enable Conditions
  • Sensor preheating and full heating phases finished
  • Fuel Cut Off active
  • Integrated Mass Air Flow since begin fuel cut-off < 20g
Threshold Value
  • Voltage with fuel cut off < 0.2V
Diagnostic Time
  • 5 Sec.
Case 2) DTC Strategy
  • Sensor voltage excursion
Enable Conditions
  • Sensor preheating and full heating phases finished
  • 5 Cycles of A/F Closed Loop passed after lambda control active.
  • Lambda controller is not on the limit
  • Battery voltage < 10V
Threshold Value
  • Sensor voltage > 0.25V
Diagnostic Time
  • 2 min.
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.