SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005SANTA FE GLS, 2.7 D, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2.7L) (1 OF 2)DTC TROUBLESHOOTING PROCEDURESDTC P0111: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCECOMPONENT INSPECTION
2005 Hyundai Santa Fe GLS, 2.7 D, AWD

Component Inspection

2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Component Inspection
  1. Measure resistance between terminals 1 and 2 of the sensor connector (Component side).

    Specification:

    IAT SENSOR TEMPERATURE/RESISTANCE SPECIFICATIONS

    Temperature Resistance (kΩ)
    20°C (68°F) Approx. 2.22 ~ 2.82
    40°C (104°F) Approx. 1.06 ~ 1.31
    80°C (176°F) Approx. 0.29 ~ 0.36
    Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Sensor Connector (Component Side)
    G03846119Courtesy of HYUNDAI MOTOR CO.
  2. Is IAT sensor data within the specification?

    YES 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Check IAT sensor for contamination, deterioration, or damage. Substitute with a known-good IAT sensor and check for proper operation. If the problem is corrected, replace IAT sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.