Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005SANTA FE GLS, 2.7 D, AWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (2.7L) (1 OF 2)DTC TROUBLESHOOTING PROCEDURESDTC P0036: HO2S HEATER CONTROL CIRCUIT (BANK 1/SENSOR 2)POWER SUPPLY CIRCUIT INSPECTION
2005 Hyundai Santa Fe GLS, 2.7 D, AWD
Power Supply Circuit Inspection
2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Power Supply Circuit Inspection
- Ignition "OFF"
- Disconnect HO2S connector.
- Ignition "ON" & Engine "OFF".
- Measure voltage between terminal 3 of the HO2S heater harness connector and chassis ground.
Specification: Approx. B+
- Is voltage within the specification?
YES
- Go to "CONTROL CIRCUIT INSPECTION " procedure.
NO
- Check for an open in the power circuit between the main relay and the HO2S.
- Especially check for "20A ECU #2 fuse" is installed and not blown.
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.