Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005SANTA FE GLS, 2.7 D, AWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLABS (ANTI-LOCK BRAKE SYSTEM)SPECIFICATION
2005 Hyundai Santa Fe GLS, 2.7 D, AWD
Abs (Anti-Lock Brake System): Specification
2005 Hyundai Santa Fe GLS, 2.7 D, AWDSECTION Specification
ANTI-LOCK BRAKE SYSTEM SPECIFICATIONS
| Part | Standard value | Remark |
|---|---|---|
| System | ||
| Type | X split 4 channel/4 sensor system | |
| Mode | ABS + EBD + TCS | |
| ECU | ||
| Operating voltage | 10V ~ 16V | |
| Operating temperature | -40°C ~ 110°C | |
| Warning lamp | ||
| ABS / EBD / TCS | ||
|
12V | |
|
Max. 200mA | |
| Wheel speed sensor | ||
| Frequency | 15 ~ 2,000 Hz | |
| Voltage | Min. 130 mVp.p (at 15 Hz) | |
| Internal resistance | ||
|
1,385 +/- 110Ω | |
|
1,385 +/- 110Ω | |
| Insulation resistance | Min. 1000kΩ | |
| Air gap | ||
|
0.3 ~ 0.9 mm | |
|
0.3 ~ 0.9 mm | |
| Tone wheel | 47 teeth | |
| HECU (Hydraulic and Electronic Control Unit) |
|
|
| Motor power | 250W | |
| Accumulator amount | ||
|
3.0 cc | |
|
0.13 cc | |
| NO solenoid valve | ||
|
Diameter 0.63 mm | |
|
Diameter 0.355 mm | |
| NC solenoid valve | ||
|
Diameter 0.63 mm | |
|
Diameter 0.40 mm | |
| Pump orifice | Diameter 0.5 mm | |
| TC valve relief pressure | 120 ~ 150 bar | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.