Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005ELANTRA GLS, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSFUEL SYSTEMDTC TROUBLESHOOTING PROCEDURESDTC P0267: CYLINDER 3-INJECTOR CIRCUIT LOWCOMPONENT INSPECTION
2005 Hyundai Elantra GLS, 4D Hatchback, Automatic
Component Inspection
2005 Hyundai Elantra GLS, 4D Hatchback, AutomaticSECTION Component Inspection
- Ignition "OFF".
- Disconnect injector connector.
- Measure resistance between terminals 1 and 2 of the injector connector(Component side).
SPECIFICATION
INJECTOR RESISTANCE SPECIFICATIONSInjector Normal Parameter At 20°C (68°F) Coil Resistance 13.8 ~ 15.2Ω Insulation Resistance Above 10MΩ - Is resistance within the specification?
YES
- Go to next step as below.
NO
- Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to VERIFICATION OF VEHICLE REPAIR procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.