Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005ELANTRA GLS, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMDTC TROUBLESHOOTING PROCEDURESDTC P0605: INTERNAL CONTROL MODULE READ ONLY MEMORY(ROM) ERRORVERIFICATION OF VEHICLE REPAIR
2005 Hyundai Elantra GLS, 4D Hatchback, Automatic
Verification Of Vehicle Repair
2005 Hyundai Elantra GLS, 4D Hatchback, AutomaticSECTION Verification Of Vehicle Repair
After a repair, it is essential to verify that the fault has been corrected.
- Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
- Press F4(DTAL) and confirm that "DTC Readiness Flag" indicates "Complete". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
- Read "DTC Status" parameter.
- Is parameter displayed "History(Not Present) fault"?
YES
- System performing to specification at this time. Clear the DTC.
NO
- Go to the applicable troubleshooting procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.