Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2005ELANTRA GLS, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSPOWER DOOR LOCKSPOWER DOOR LOCK RELAYINSPECTION

2005 Hyundai Elantra GLS, 4D Hatchback, Automatic

Power Door Lock Relay: Inspection

2005 Hyundai Elantra GLS, 4D Hatchback, AutomaticSECTION Inspection

Remove the negative(-) battery terminal.
Remove the center fascia panel then remove the audio and the heater control unit.
Remove the door lock control module (A) from the right side center support bracket.

Fig 1: Removing Door Lock Control Module (A) From Right Side Center Support Bracket
Courtesy of HYUNDAI MOTOR CO.
Disconnect the 9P connector(B) from the door lock control module, then check for continuity between the terminals.

Fig 2: Identifying Door Lock Control Module 9P Connector(B)
Courtesy of HYUNDAI MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.