SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005ELANTRA GLS, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSETACS (ELECTRONIC TIME AND ALARM CONTROL SYSTEM)ELECTRONIC TIME AND ALARM CONTROL MODULEETACS MODULE INPUT SIGNAL TESTNOTES
2005 Hyundai Elantra GLS, 4D Hatchback, Automatic

ETACS Module Input Signal Test: Notes

2005 Hyundai Elantra GLS, 4D Hatchback, AutomaticSECTION Notes
  1. Disconnect the wire connector(B) from the ETACS module(A).
  2. Inspect the connector(B) on wire harness side as shown in Fig 1 .
    Fig 1: Identifying ETACS Module Connectors
    G03844130Courtesy of HYUNDAI MOTOR CO.
    ETACS MODULE REFERENCE CHART

    Terminal No. Connector A Connector B Connector C
    1 B+ Driver door unlock relay -
    2 Air bag signal Door warning switch -
    3 Rear door lock switch Chime bell Key hole illumination lamp
    4 Power window relay Seat belt switch Code saving
    5 IGN1 Driver door lock switch Driver door key unlock switch
    6 IGN2 Assist door lock switch Driver door key lock switch
    7 - Washer switch (1) Hood switch
    8 Driver door switch Intermittent wiper switch (1) Hazard lamp relay
    9 Assist door switch Intermittent wiper volume (1) Siren
    10 Trunk switch Wiper relay (1) Trunk key unlock switch (only 4 doors)
    11 Room lamp - -
    12 Rear defogger relay Rear defogger switch (1) Burglar alarm relay
    13 Seat belt-warning lamp -  
    14 Door lock relay Tail lamp switch  
    15 Tail lamp relay -  
    16 Ground D.R.L  
    17 -    
    18 Door switch    
    19 Alternator "L"    
    20 Door unlock relay    
    NOTE:
    (1) : only Keyless entry & Burglar alarm system.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.