Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reading Readiness Code
Readiness code is returned to 0 1 1 0 1 1 0 1 if DTC memory is erased, voltage supply to ECM is lost, or a new ECM is installed. To read readiness code, connect scan tool to DLC. DLC is located left side of steering column. Turn ignition on. Follow scan tool manufacturer's instructions and read Readiness Code. See Figure. Readiness code should display 0 0 0 0 0 0 0 0. If readiness code displays as specified, testing is complete. If readiness code does not display as specified, generate readiness code. See GENERATING READINESS CODE .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.