Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2003XG350 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSELECTRONIC TIME & ALARM CONTROL SYSTEMREMOVAL AND INSTALLATIONETACS CONTROL MODULE

2003 Hyundai XG350 Base

ETACS Control Module

2003 Hyundai XG350 BaseSECTION ETACS Control Module

Disconnect the negative (-) battery terminal.
Remove the lower crash pad panel.

Fig 1: Removing Lower Crash Pad Panel
Courtesy of HYUNDAI MOTOR CO.
Disconnect the connectors and remove the ETACS CM.

Fig 2: Removing ETACS Control Module
Courtesy of HYUNDAI MOTOR CO.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.