Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003XG350 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL SYSTEMCANCELLATIONNOTES
2003 Hyundai XG350 Base
Cruise Control System: Cancellation: Notes
2003 Hyundai XG350 BaseSECTION Notes
Regulated speed run shall be released when external switches are switched as following.
- Stop lamp switch is turned "ON".
(Brake pedal is depressed)
This also applies to the disconnection of the input wire.
- Brake switch or CANCEL switch is turned "ON". (Brake pedal is depressed)
- Inhibitor switch is turned "ON".
(Gear shift lever is in either P or N position.)
- Ignition key switch is turned "OFF".
- SPORTS MODE is turned "ON".
- MAIN switch is turned "OFF".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.