2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection

Factory service manual diagram



ENGINE COOLANT TEMPERATURE SENSOR (ECT SENSOR)

The engine coolant temperature sensor, located in the engine coolant passage of the cylinder head. It detects the engine coolant temperature and relays signals to the ECM. It employs a thermistor which is sensitive to changes in temperature. The electric resistance of a thermistor decreases in response to temperature rise. The ECM judges engine coolant temperature by the sensor output voltage and provides optimum fuel enrichment when the engine is cold.


Circuit Diagram:

Factory service manual diagram





Using Hi-Scan (Pro):

Factory service manual diagram





Using Voltmeter:

Factory service manual diagram





Harness Inspection Procedures:

Factory service manual diagram





SENSOR INSPECTION
1. Remove the engine coolant temperature sensor from the intake manifold.

Factory service manual diagram



Factory service manual diagram



2. With the temperature sensing portion of the engine coolant temperature sensor immersed in hot water, check resistance.
3. If the resistance deviates from the standard value greatly, replace the sensor.

INSTALLATION
1. Apply sealant LOCTITE 962T or equivalent to threaded portion.
2. Install engine coolant temperature sensor and tighten it to specified torque.

Tightening torque
Engine coolant temperature sensor: 15 - 20 Nm (150 - 200 kg.cm, 11 - 15 lb.ft)

3. Connect the harness connector securely.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.