Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAXLE SYSTEMGENERALDIAGNOSTIC TROUBLE CODE IDENTIFICATION
2003 Hyundai Tiburon Base, Automatic
Diagnostic Trouble Code Identification
2003 Hyundai Tiburon Base, AutomaticSECTION Diagnostic Trouble Code Identification
DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Definition |
|---|---|
| P0703 | Stop Light Switch System |
| P0712 | Oil Temperature Sensor System |
| P0713 | Oil Temperature Sensor System |
| P0715 | Input Shaft Speed Sensor System |
| P0720 | Output Shaft Sensor System |
| P0725 | Crankshaft Position Sensor System |
| P0731 | 1st Gear Incorrect Ratio |
| P0732 | 2nd Gear Incorrect Ratio |
| P0733 | 3rd Gear Incorrect Ratio |
| P0734 | 4th Gear Incorrect Ratio |
| P0736 | Reverse Gear Incorrect Ratio |
| P0740 | Torque Converter Clutch Solenoid System |
| P0743 | Torque Converter Clutch Solenoid System |
| P0750 | Solenoid Valve System |
| P0755 | Solenoid Valve System |
| P0760 | Solenoid Valve System |
| P0765 | Solenoid Valve System |
| P1702 | Throttle Position Sensor System |
| P1703 | Throttle Position Sensor System |
| P1704 | Throttle Position Sensor System |
| P1723 | A/T Control Relay System |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.