Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSDIAGNOSTIC CONNECTOR (DLC) LOCATIONSIMPORTED CARS & TRUCKSCHRYSLER GROUP LLC
2003 Hyundai Tiburon Base, Automatic
CHRYSLER Group LLC
2003 Hyundai Tiburon Base, AutomaticSECTION CHRYSLER Group LLC
NOTE:
This table provides a quick reference for self-diagnostic connector locations, when available from manufacturer, that ARE NOT
located at the lower left side of the dash, as mandated in 1996 by the Federal government.
CHRYSLER GROUP LLC - IMPORTED CARS & TRUCKS
| Application | Connector Location | |
|---|---|---|
| Colt & Summit | ||
| 1986-87 | Above Inside Of Glove Compartment | |
| 1988 | On Left Rear Corner Of Engine Compartment | |
| 1989-98 | Under Left Side Of Dash, Near Fuse/Relay Block | |
| Colt Vista | ||
| 1987 | Behind Glove Compartment | |
| 1988-89 | Under Left Side Of Dash, Near Hood Release Handle | |
| 1990-96 | Under Right Side Of Dash | |
| Conquest & Starion | Behind Glove Compartment | |
| Expo | Under Left Side Of Dash, Near Fuse/Relay Block | |
| Medallion | On Left Side Of Firewall | |
| Pickup | Under Left Side Of Dash, Near Fuse/Relay Block | |
| Ram-50 | Under Left Side Of Dash, Near Fuse/Relay Block | |
| Sigma | In Glove Compartment | |
| Stealth | ||
| 1991-98 | Under Left Side Of Dash, On Fuse/Relay Block | |
| 1999 | Under Left Side Of Dash, Left Of Center Console | |
| Summit Wagon | Under Right Side Of Dash | |
| Vista Wagon | Under Right Side Of Dash | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.