SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003SANTA FE GLS, 2.7 D, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURESFUEL SYSTEMENGINE CONTROL RELAYENGINE CONTROL RELAY TEST (SANTA FE, SONATA & XG350)
2003 Hyundai Santa Fe GLS, 2.7 D, FWD

Engine Control Relay Test (Santa Fe, Sonata & XG350)

2003 Hyundai Santa Fe GLS, 2.7 D, FWDSECTION Engine Control Relay Test (Santa Fe, Sonata & XG350)

Sonata 2.4L and XG350 are equipped with an 8-pin engine control relay. See Fig 1. Sonata 2.7L is equipped with a 5-pin engine control relay. See Figure. Engine control relay Information on Santa Fe is not available from manufacturer. Component testing information is not available from manufacturer.

Fig 1: Identifying Engine Control Relay 8-Pin Connector Terminals (Component Side)
G99A03471Courtesy of HYUNDAI MOTOR CO.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.