Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003ACCENT L4-1.5LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSUSPENSIONBALL JOINTSERVICE AND REPAIR
2003 Hyundai Accent L4-1.5L
Ball Joint: Service and Repair
2003 Hyundai Accent L4-1.5LSECTION Service and Repair
BALL JOINT AND DUST COVER REPLACEMENT
1. Using a screwdriver, remove the dust cover from the lower arm ball joint.
2. Remove the snap ring.
3. Using a plastic hammer, disconnect the ball joint from the lower arm. Hammering with the special tool (09545-3A000) placed under the lower arm as shown may prevent the deformation of the lower arm.
4. Using Special Tool (09545-1 1000), press the ball joint into the lower arm assembly.
Unless it it pressed firmly, the snap ring will not fit perfectly to the groove.
5. Install the snap ring.
6. If there is not sufficient grease on the ball joint assembly, apply grease abundantly.
7. Using special tool(09545-21100), install the dust cover. The Special Tool will make the installation process even easier.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.