Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003ACCENT L4-1.5LREPAIR AND DIAGNOSISINSTRUMENT PANEL, GAUGES AND WARNING INDICATORSDASHBOARD / INSTRUMENT PANELSERVICE AND REPAIRCENTER FACIA PANEL
2003 Hyundai Accent L4-1.5L
Center Facia Panel
2003 Hyundai Accent L4-1.5LSECTION Center Facia Panel
REMOVAL AND INSTALLATION
CAUTION:
- When using a screwdriver or equivalent, wrap it with protective tape to prevent damage.
- Wear gloves to protect hands from injury.
NOTE: Take care not to scratch the crash pad.
1. Remove the glove box.
2. Remove the crash pad lower panel.
3. Disconnect the intake control mode, mode control, and air mix control cable. Remove the center facia panel from the lower portion with a trim remover.
4. Loosen the 4 mounting screws and remove the audio assembly.
5. Installation is the reverse of removal.
CAUTION:
- When using a screwdriver or equivalent, wrap it with protective tape to prevent damage.
- Wear gloves to protect hands from injury.
NOTE: Take care not to scratch the crash pad.
1. Remove the glove box.
2. Remove the crash pad lower panel.
3. Disconnect the intake control mode, mode control, and air mix control cable. Remove the center facia panel from the lower portion with a trim remover.
4. Loosen the 4 mounting screws and remove the audio assembly.
5. Installation is the reverse of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.