Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
UNDERDRIVE Clutch And Input Shaft: Reassembly
2002 Hyundai XG350 BaseSECTION Reassembly
- Install the 2 D-ring seals.
- Install the underdrive clutch piston.
- Install the clutch return spring.
- Install the D-ring seal.
- Install the clutch spring retainer.
- Compress the clutch return springs using special tools, 09453-21100 and 09453-21000, then install the clutch spring retainer snap ring.CAUTION: Dip each clutch disc in ATF before assembling.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.