Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2002XG350 BASEREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSBENCH TESTINGARMATURE TEST
2002 Hyundai XG350 Base
Armature Test
2002 Hyundai XG350 BaseSECTION Armature Test
- To check armature for a grounded circuit, check continuity between commutator and armature coil core. See Fig 1 . No continuity should exist. Replace armature if continuity exists.
- To check for an open circuit, check continuity between individual brush segments at commutator end of armature. See Fig 1 . Continuity should exist between each individual brush segment. Replace armature if no continuity exists on any brush segment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.