Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2002SANTA FE BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL2.4L 4-CYLINDER ENGINEINTAKE AND EXHAUST SYSTEMEXHAUST MANIFOLD AND CATALYTIC CONVERTERINSTALLATION
2002 Hyundai Santa Fe Base, Automatic
Exhaust Manifold And Catalytic Converter: Installation
2002 Hyundai Santa Fe Base, AutomaticSECTION Installation
- Install the exhaust manifold with its gasket.
Tightening torque
Exhaust manifold
M8 : 25 ~ 30 Nm (250 ~ 300 kg.cm, 18 ~ 22 lb.ft)
M10 : 35 ~ 35 Nm (350 ~ 550 kg.cm, 25 ~ 40 lb.ft)
NOTE:
Do not use the used exhaust manifold gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.