Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSHYUNDAI1999ELANTRA WAGON L4-2.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOXYGEN SENSORTESTING AND INSPECTION
1999 Hyundai Elantra Wagon L4-2.0L
Oxygen Sensor: Testing and Inspection
1999 Hyundai Elantra Wagon L4-2.0LSECTION Testing and Inspection
Engine Control System (Part 1 Of 7):
1999 Tiburon 2.0 L
1999 Elantra 2.0 L
CIRCUIT DIAGRAM
HARNESS INSPECTION PROCEDURE
SENSOR INSPECTION
NOTE
1. Before checking, warm up the engine until the engine coolant temperature reaches 80 to 95 °C (176 to 205 °F).
2. Use an accurate digital voltmeter.
Replace the oxygen sensor if there is a malfunction.
1. Disconnect the heated oxygen sensor connector, and measure the resistance between terminal 3 and terminal 4.
Standard Value
Temperature 400 °C Resistance 30 or more Ohms
2. Replace the oxygen sensor if there is a malfunction
Tightening Torque
Heated Oxygen Sensor 50 - 60 Nm (500 - 600 kg.cm, 37 - 44 lb.ft)
TROUBLESHOOTING PROCEDURES
TROUBLESHOOTING HINTS
When the lean/rich period is above 2.6 seconds in the condition that fully warm-up engine is 2,000 - 3,000 rpm and engine is above middle load.
TROUBLESHOOTING HINTS
1. If the heated oxygen sensor is defective abnormally, high emissions may occur.
2. If the heated oxygen sensor check has been normal, but the sensor output voltage is out of specification, check the following items related to the air fuel ratio control system.
- Faulty injector.
- Air leaks in the intake manifold.
- Faulty mass air flow sensor, EVAP valve and engine coolant temperature sensor.
- Wiring connection problem.
3. When 02 sensor output voltage is maintained as following for above 50 seconds.
- Upstream 0.4 V - 0.6 V
- Downstream : 0.4 V - 0.5 V
USING VOLTMETER
NOTE: If you release the accelerator pedal suddenly with the engine running about 4000 rpm, the fuel supply will be stopped for a while. When you suddenly press the accelerator pedal, the voltage will reach 'B' range. Then, when you let the engine idle again, the voltage fluctuates between 'A' and 'B' range. In this case, the O2 sensor can be determined as good.
AIR-FUEL CONTROL TROUBLESHOOTING PROCEDURE
TROUBLESHOOTING HINTS
Air/Fuel ratio stays rich or lean longer than specified period because of system malfunction.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.