Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1999ELANTRA WAGON L4-2.0LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSERVICE AND REPAIRDISCHARGING REFRIGERANT SYSTEM
1999 Hyundai Elantra Wagon L4-2.0L
Discharging Refrigerant System
1999 Hyundai Elantra Wagon L4-2.0LSECTION Discharging Refrigerant System
Use the refrigerant recovery unit to discharge refrigerant gas from the system.
Federal regulations require that the discharging of R-134a refrigerant be performed by a licensed technician using only an approved recovery and/or recycling system. Do not discharge R134a refrigerant into the atmosphere. When discharging the refrigerant system, always follow the recovery or recycling system equipment manufacturer's instructions.
NOTE: Refer to the refrigerant recovery and recycling unit instruction manual for operation of the unit.
Federal regulations require that the discharging of R-134a refrigerant be performed by a licensed technician using only an approved recovery and/or recycling system. Do not discharge R134a refrigerant into the atmosphere. When discharging the refrigerant system, always follow the recovery or recycling system equipment manufacturer's instructions.
NOTE: Refer to the refrigerant recovery and recycling unit instruction manual for operation of the unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.