Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1999ELANTRA WAGON L4-2.0LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYSERVICE AND REPAIRENGINE MOUNTS
1999 Hyundai Elantra Wagon L4-2.0L
Engine Mounts
1999 Hyundai Elantra Wagon L4-2.0LSECTION Engine Mounts
DISASSEMBLY
Attach an engine hoist to the engine hooks, and raise the engine just enough so that there is no pressure on the insulators.
Engine Mounting
1. Remove the engine mount insulator bolts.
2. Remove the engine mount bracket from the engine.
Transaxle
1. For vehicles with a 5-speed manual transaxle, remove the select control valve.
2. Remove the transaxle mount bolt.
3. Detach the cap from inside the right fender shield. Remove the transaxle mounting bolts.
4. Remove the transaxle bracket.
Front Roll Stopper
Remove the front roll stopper bracket from the center member.
Rear Roll Stopper
Remove the rear roll stopper from the center member.
Center member
1. Remove the under cover (R.H.).
2. Remove the front roll stopper mounting bolts.
3. Remove the rear roll stopper mounting bolts.
4. Remove the center member from the body.
INSPECTION ITEMS
Attach an engine hoist to the engine hooks, and raise the engine just enough so that there is no pressure on the insulators.
Engine Mounting
1. Remove the engine mount insulator bolts.
2. Remove the engine mount bracket from the engine.
Transaxle
1. For vehicles with a 5-speed manual transaxle, remove the select control valve.
2. Remove the transaxle mount bolt.
3. Detach the cap from inside the right fender shield. Remove the transaxle mounting bolts.
4. Remove the transaxle bracket.
Front Roll Stopper
Remove the front roll stopper bracket from the center member.
Rear Roll Stopper
Remove the rear roll stopper from the center member.
Center member
1. Remove the under cover (R.H.).
2. Remove the front roll stopper mounting bolts.
3. Remove the rear roll stopper mounting bolts.
4. Remove the center member from the body.
INSPECTION ITEMS
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.