Washer Switch

1998 Hyundai Tiburon Base, StandardSECTION Washer Switch

Disconnect multifunction switch harness connectors. Check continuity in each switch position, between indicated switch terminals. See WASHER SWITCH CONTINUITY TESTΒ  table. See Figure, Figure, Figure or Figure . If continuity does not exist, replace multifunction switch.

WASHER SWITCH CONTINUITY TEST

Switch Position Connector Continuity Between Terminals No.
Accent (1)
Off B (2)
On B 1 & 4
Elantra (3)
Off B (4)
On B 8 & 10
Sonata (5)
Off A (6)
On A 8 & 16
Tiburon (With EPS (7))
Off A (8)
On A 11 & 13
Tiburon (Without EPS (9))
Off A (4)
On A 8 & 10
(1) See Figure.
(2) Continuity should not exist between terminals No. 1 and 4.
(3) See Figure.
(4) Continuity should not exist between terminals No. 8 and 10.
(5) See Figure.
(6) Continuity should not exist between terminals No. 8 and 16.
(7) All models with Electronic Power Steering (EPS) have air bags. See Figure.
(8) Continuity should not exist between terminals No. 11 and 13.
(9) Models without Electronic Power Steering (EPS) come with or without air bags. See appropriate illustration for connector identification. See Figure or Figure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.