Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVE/INSTALL/OVERHAULTORQUE SPECIFICATIONS
1998 Hyundai Tiburon Base, Automatic
Torque Specifications
1998 Hyundai Tiburon Base, AutomaticSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Distributor Hold-Down Nut | 9-16 (12-19) |
| Fuel Tank Drain Plug | 11-18 (15-25) |
| Heated Oxygen Sensor (HO2S) (Except Sonata) | 37-44 (50-60) |
| Heated Oxygen Sensor (HO2S) (Sonata) | 29-36 (40-50) |
| High Pressure Hose-To-Fuel Filter | 18-25 (25-35) |
| High Pressure Hose-To-Fuel Tank | 22-29 (30-40) |
| Intake Manifold (Plenum) Bolt | 11-15 (15-20) |
| Knock Sensor (Except Sonata) | 11-15 (15-20) |
| Spark Plug | 15-22 (20-30) |
| Throttle Body Bolt (Except Sonata) | 11-15 (15-20) |
| INCH Lbs. (N.m) | |
| Camshaft Position Sensor Bolt | 71 (8.0) |
| Crankshaft Position Sensor Bolt (Except Accent) | 35-54 (4.0-6.0) |
| Crankshaft Position Sensor Bolt (Accent) | 80-97 (9.0-11.0) |
| Fuel Pump-To-Fuel Tank Screw | 17-26 (2.0-3.0) |
| Fuel Rail Bolt | 84-108 (10.0-12.0) |
| High Pressure Hose-To-Fuel Rail | 26-36 (3.0-4.0) |
| Throttle Body Bolt (Sonata) | 89-115 (10.0-13.0) |
| TP Sensor Mounting Screw | 13-22 (1.5-2.5) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.