Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1998TIBURON BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERBENCH TESTINGNO-LOAD TEST
1998 Hyundai Tiburon Base, Automatic
No-Load Test
1998 Hyundai Tiburon Base, AutomaticSECTION No-Load Test
- Place starter in soft-jawed vise. Rotate carbon pile rheostat to the off position. Connect fully charged 12-volt battery, switch, voltmeter (15-volt scale), ammeter (100-amp scale) and carbon pile rheostat as shown. See Fig 1 . Adjust carbon pile rheostat until voltmeter indicates 11.0-11.5 volts.
- Connect remote starter switch between solenoid terminals "B" and "S". Activate remote switch (maximum 10 seconds), and note reading on ammeter. Ensure starter rotates smoothly and maximum amperage draw is within specification. Refer to the STARTER NO-LOAD SPECIFICATIONS table. If starter does not test as specified, replace starter.
STARTER NO-LOAD SPECIFICATIONS
| Application | Amps @ Minimum RPM |
|---|---|
| Accent | 60 @ 3000 |
| Elantra, Sonata & Tiburon | 90 @ 3000 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.