Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Door Glass: Stopper
With glass fully closed, glass edge must be parallel to weather strip at roof section and 2 stoppers must simultaneously come into contact. Loosen 2 stopper mounting bolts. Adjust as necessary. See Fig 5. Tighten stopper catch to 85-120 INCH lbs. (9-14 N.m). Tighten glass stopper to 36-48 INCH lbs. (4-6 N.m).
Close door and glass fully. Check for water leaks. Adjust as necessary. Install door trim seal and trim panel.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.