Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1994SCOUPE LS, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSA/C-HEATER SYSTEM - MANUALTROUBLE SHOOTINGCONDENSER FAN DOES NOT RUN
1994 Hyundai Scoupe LS, Automatic
Condenser Fan Does Not Run
1994 Hyundai Scoupe LS, AutomaticSECTION Condenser Fan Does Not Run
- Check Pink fusible link "C" (30-amp) in main fusible link box, and replace if necessary. If fusible link is okay, turn ignition off. Disconnect condenser fan motor relay (located in engine compartment relay box). Turn ignition, blower and A/C switches on.
- Measure voltage between condenser fan motor relay Light Green wire terminal and ground. If battery voltage exists, go to next step. If battery voltage does not exist, turn ignition off. Repair open in Light Green or Black/Light Green wires between relay and thermo switch.
- Measure voltage between condenser fan motor relay Green/Yellow wire terminal and ground. If battery voltage exists, go to step 6). If battery voltage does not exist, go to next step.
- Disconnect condenser fan motor. Measure voltage between Blue wire terminal and ground. If battery voltage exists, go to next step. If battery voltage does not exist, repair open in Blue wire between condenser fan motor and Blue fusible link "B" (20-amp).
- Reconnect condenser fan motor. Connect a jumper wire between condenser fan motor Black wire terminal and ground. Condenser fan should run. If condenser fan runs, repair poor connection or open circuit between condenser fan motor Black wire terminal and ground. If condenser fan does not run, replace condenser fan motor.
- Connect a jumper wire between condenser fan motor relay Green/Yellow wire terminal and ground. Condenser fan should run. If condenser fan runs, replace condenser fan relay. If condenser fan does not run, go to next step.
- Turn ignition off. Measure continuity between condenser fan motor relay Black wire terminal and ground. Continuity should exist. If continuity exists, circuit is okay. If continuity does not exist, repair poor connection or open Black wire between condenser fan motor relay and ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.