Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1994SCOUPE BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVE/INSTALL/OVERHAULIGNITION SYSTEMDISTRIBUTORDISASSEMBLY
1994 Hyundai Scoupe Base, Standard
Ignition System: Distributor: Disassembly
1994 Hyundai Scoupe Base, StandardSECTION Disassembly
- Lightly clamp distributor in soft-jawed vise. Remove rotor, gasket and plastic cover. See Fig 1 . Remove rotor shaft screw. Remove rotor shaft (using puller if necessary).
- Remove optical disc and spacer(s). Disconnect lead wire connector. Remove base plate mounting screws. Lift out base plate and optical unit. Remove distributor shaft bearing screws.
- Remove coupling spring. See Fig 1 . Mark distributor shaft and gear position for reassembly. Support gear on soft wooden block and drive out roll pin. Remove gear and distributor shaft from distributor housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.