Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1994EXCEL GL, AUTOMATIC, KM171REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTSIDLE CONTROL SYSTEMIDLE SPEED CONTROL MOTOR
1994 Hyundai Excel GL, Automatic, KM171
Idle Speed Control Motor
1994 Hyundai Excel GL, Automatic, KM171SECTION Idle Speed Control Motor
- Disconnect Idle Speed Control (ISC) motor connector. Check motor coil continuity between motor terminals. Resistance should be 5-70 ohms at 68°F (20°C). If resistance is not as specified, an open or short exists in motor coil. Replace ISC servo assembly.
- Connect 6 volts DC (four 1.5-volt DC batteries) between ISC motor terminals to operate ISC motor. DO NOT apply more than 6 volts. If motor does not operate, replace ISC motor assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.