Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1991SONATA V6-3.0LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSTESTING AND INSPECTIONWASHER SYSTEM
1991 Hyundai Sonata V6-3.0L
Washer System
1991 Hyundai Sonata V6-3.0LSECTION Washer System
Fig. 5 Washer Motor Operation Check:
1. With the washer motor installed in the washer tank, fill the tank with washer fluid.
2. Connect the positive lead from battery voltage to terminal 2 and negative lead to ground, Fig. 5.
3. Ensure washer motor runs and washer fluid is ejected.
4. If fluid is not ejected, check washer fluid contact point.
5. Adjust washer fluid contact point by using a metal wire to move the washer nozzle ball.
6. If the amount of washer fluid ejected is too little, check for clogged, bent or crushed piping. Check the clipped points as the tube may be crushed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.