Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI1991SONATA V6-3.0LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSTESTING AND INSPECTIONFRONT WIPER SYSTEMAUTOMATIC STOP OPERATION CHECK
1991 Hyundai Sonata V6-3.0L
Automatic Stop Operation Check
1991 Hyundai Sonata V6-3.0LSECTION Automatic Stop Operation Check
Fig. 3 Automatic Stop Operation:
1. Operate the motor at low speed.
2. Stop motor operation anywhere except at the Off position by disconnecting terminal 5, Fig. 3.
3. Connect terminal 5 and 6 by a jumper wire.
4. Connect the positive lead from battery to terminal 1. Check that motor stops running at the Off position after the motor operates again.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.